2 Cable PWMMKPJ1

Contents of this section

See the Haystack drawing 4712A101 for a reference description of this cable. Alpha cable 4x20AWG wire type ``1896/4C'' is used.

PWM rear panel connector J9 will accept AMP plug 206708-1 with large AMP 163088-2 socket contacts and a standard cable clamp AMP 206966-1. At the Mark~III Power Supply end of this cable, this station uses:

Our cable pinout is:

PWM rear  -- 1220mm/48" cable --  Mark III Pwr
-------------------------------------------------------------------
                                 Add connector name and pin # here:
J9-1 -- polarizing plug AMP 200821-1
J9-3 -- green -- (-12V):

J9-4 -- red   -- (+12V):

J9-5 -- black -- (RETURN):


This information was written down:

Next Chapter, Previous Chapter

Table of contents of this chapter, General table of contents

Top of the document, Beginning of this Chapter